Skip to main content

V1

Major VersionM

by Mid City Support

Introduction

The programming options are determined by the position of the turn signal/high beam stalk during the programming sequence.

  • To select a programming option, put the stalk in the corresponding position before starting the programming sequence.

The programming options for the 907-OBD-MIR are as follows:

Option 1 (default): Stalk neutral

  • Mirrors fold in with lock from OEM key fob, fold out with unlock from OEM key fob.

Option 2: Stalk down/left turn signal

  • Mirrors fold in with lock from OEM key fob, mirrors fold out when door is opened.

Option 3: Stalk up/right turn signal

  • Return to OEM settings

Note: the OBD programmers are for use in 1 vehicle. Once the programmer is used, it can only be used in the same vehicle again.

Attention: The OBD programmer should be removed after use. Do not start engine or drive vehicle with OBD programmer installed.

Video Overview

    • Set turn signal stalk position to choose programing option. For default programming, leave stalk in neutral position. See above introduction above for programming option selection.

    • Press push to start button 2X to turn on ignition

    • Do not start engine

    • Ignition is the 2nd position, all warning lights will be on instrument cluster

    • Press push to start button 1X to turn ignition off

    • This step is to wake up the vehicle

    • Plug OBD programmer into OBD port

    • LED should turn on (inside case, look through hole at the end of the case)

    • Press push to start button 2X to turn ignition on

    • Check LED inside programmer

    • When LED turns off, programming is complete

    • Sometimes the programming occurs very quickly (LED turns off immediately after ignition is turned on)

    • If LED does not turn off within 5 minutes, repeat programming steps- but try to complete steps 2 and 3 within 10 seconds.

    • Do not start engine

    • Ignition is the 2nd position, all warning lights will be on instrument cluster

    • Make sure to remove programmer after process is complete. Do not drive with the programmer plugged in.

Conclusion

Attention: The OBD programmer should be removed after use. Do not start engine or drive vehicle with OBD programmer installed.

For support, contact Mid City Engineering:

www.midcityengineering.com/support

312-421-1114

Mid City Support

Member since: 07/31/2018

50 Guides authored