Skip to main content

V6

Major VersionM

by Mid City Support

Introduction

Installation of this harness involves following:

  • Connection of antenna plug to factory antenna plug on underside of roof
  • Running harness down 'A' pillar and into dash behind radio cavity
  • Connection to antenna port on radio
    • Using pry tool, release and lower dome light console

    • Carefully un-plug white connector from dome console

    • Un-plug blue connector from harness where felt terminates

    • Set aside dome light console

    • Illuminate light cavity and locate connector panel on under side of roof

    • Plug antenna adapter into open connector on driver side, closest to windshield

    • Separate plastic pieces around mirror bracket and remove

    • This step is also required for installation of the 907CAM factory camera adapter- so if also installing that harness, it is recommended to make that connection now.

    • Route harnessing along headliner over to passenger side 'A' pillar

    • This step through step 8 are also required for installation of the 907CAM factory camera adapter- so if also installing that harness, it is recommended that the harnessing is run at the same time

    • Remove trim along 'A' pillar

    • Run and secure cable down 'A' pillar

    • Remove small plastic panel at end of dash

    • Pull off door seal

    • Remove 3 x T20 screws along top of bolster pocket

    • Remove 2 x T20 screws along right side of knee bolster

    • Remove 3 x T20 screws along bottom of knee bolster

    • Pull knee bolster panel from dash and set aside

    • Route cable through dash and behind where radio will be mounted

    • Connect antenna plug to antenna port on aftermarket radio

Finish Line

Mid City Support

Member since: 07/31/2018

46 Guides authored