Introduction
Installation of this harness involves following:
- Connection of antenna plug to factory antenna plug on underside of roof
- Running harness down 'A' pillar and into dash behind radio cavity
- Connection to antenna port on radio
-
-
Using pry tool, release and lower dome light console
-
Carefully un-plug white connector from dome console
-
Un-plug blue connector from harness where felt terminates
-
Set aside dome light console
-
-
-
Illuminate light cavity and locate connector panel on under side of roof
-
Plug antenna adapter into open connector on driver side, closest to windshield
-
-
-
Separate plastic pieces around mirror bracket and remove
-
This step is also required for installation of the 907CAM factory camera adapter- so if also installing that harness, it is recommended to make that connection now.
-
-
-
Route harnessing along headliner over to passenger side 'A' pillar
-
This step through step 8 are also required for installation of the 907CAM factory camera adapter- so if also installing that harness, it is recommended that the harnessing is run at the same time
-
-
-
Remove trim along 'A' pillar
-
Run and secure cable down 'A' pillar
-
-
-
Remove small plastic panel at end of dash
-
Pull off door seal
-
-
-
Remove 3 x T20 screws along top of bolster pocket
-
Remove 2 x T20 screws along right side of knee bolster
-
Remove 3 x T20 screws along bottom of knee bolster
-
Pull knee bolster panel from dash and set aside
-
-
-
Route cable through dash and behind where radio will be mounted
-
-
-
Connect antenna plug to antenna port on aftermarket radio
-
