Skip to main content

V1 Test

Major VersionM

by Noah Thatcher

    • Verify that power connection is good

    • Test for voltage at RS232 cable going into 907INT-C brain

  1. Make sure that CAN wires are connected at the correct location The provided CAN wires can be connected to the CAN distribution block below the A pillar on the passenger side with factory brown and brown/red wires Not every vehicle will have the distribution block with brown and brown/red wires. If no block is available, the CAN wires should be connected to the brown and brown/red wires (twisted pair) at the harness next to the fuse box under the passenger floor
    • Make sure that CAN wires are connected at the correct location

    • The provided CAN wires can be connected to the CAN distribution block below the A pillar on the passenger side with factory brown and brown/red wires

    • Not every vehicle will have the distribution block with brown and brown/red wires. If no block is available, the CAN wires should be connected to the brown and brown/red wires (twisted pair) at the harness next to the fuse box under the passenger floor

    • If connecting to the wires at the harness next to the fuse box, make sure that provided brown wire is connected to factory brown wire and provided brown/red wire is connected to factory brown/red wire

    • If connecting at the CAN distribution block, be sure that the block is used with factory brown and brown/red wires

Noah Thatcher

Member since: 07/31/2018

36 Guides authored

0 Comments

Add Comment