-
-
Using pry tool, remove panel at end of knee bolster
-
-
-
Remove two screws and panel and end of footwell
-
-
-
Turn plastic screws in counter clockwise
-
Remove panel
-
Pull back floor and remove fuse access panel
-
-
-
Pull back plastic floor
-
Remove one screw holding sill panel in place
-
-
-
Remove 2 plastic panel tabs
-
-
-
Pull back floor and remove sill panel
-
-
-
Remove bolt near door opening
-
Connect ring terminal from provided black wire on post
-
Replace bolt and tighten
-
-
-
The 907RVC-I harness comes with a red power lead terminating at a fuse holder terminal. This fuse will pin into the fuse box under the passenger floor
-
Remove provided fuse and route empty fuse holder terminal through underside of fuse box and insert into one side of fuse location marked on picture left (yellow wire shown in picture)
-
From top of the fuse box connect provided fuse to fuse holder terminal
-
-
-
Locate CAN distribution block below the A pillar with purple and purple/white wires
-
Plug provided 2 pin CAN plug into the distribution block.
-
It may be necessary to cut the keying tab on the provided 2 pin connector. See picture.
-
-
-
Connect the provided 2 pin CAN plug to any empty spot in the distribution block
-
-
-
The 907OBD-RPS includes the 907OBD360 OBD programmer. Once all of the installation steps are completed for the module (steps 1-10), follow the 907OBD360 programming instructions (click here)
-
