-
-
Turn both plastic screws in the middle of passenger kick panel (below knee bolster) counter clockwise
-
Remove panel and set aside
-
Remove screw on door side of plastic floor cover
-
Pull back plastic floor cover and remove emergency tool set and set aside
-
Fuse box and wiring harness is below emergency kit
-
-
-
Locate CAN distribution block below A pillar with purple and purple/white factory wires
-
Plug provided 2 pin white plug into any empty spot in the block with purple and purple/white factory wires
-
-
-
Connect red wire from harness to power supply being used for radio (retained accessory)
-
Connect black wire to ground source being used for radio (chassis ground)
-
-
-
Connect interface to radio input. See wiki for radio connection here: 907SWC Radio Connections
-
Almost done!
Finish Line
