Skip to main content

V1

Major VersionM

by Noah Thatcher

    • Turn both plastic screws in the middle of passenger kick panel (below knee bolster) counter clockwise

    • Remove panel and set aside

    • Remove screw on door side of plastic floor cover

    • Pull back plastic floor cover and remove emergency tool set and set aside

    • Fuse box and wiring harness is below emergency kit

  1. Locate CAN distribution block below A pillar with purple and purple/white factory wires
    • Locate CAN distribution block below A pillar with purple and purple/white factory wires

    • Plug provided 2 pin white plug into any empty spot in the block with purple and purple/white factory wires

    • Connect red wire from harness to power supply being used for radio (retained accessory)

    • Connect black wire to ground source being used for radio (chassis ground)

Finish Line

Noah Thatcher

Member since: 07/31/2018

36 Guides authored

0 Comments

Add Comment