Introduction
Instructions for connecting and programming Compustar RF remotes to SKSNG SmartKey Starter® module:
SKSNG204D3, SKSNG204D4, SKSNG166D3, SKSNG166D4, SKSNG204D4T, SKSNG166D4T, SKSNG221D3, SKSNG907, SKSNG907RV, SKSNG447D4T
NOTE: Compustar AM remotes are not supported.
-
-
All SKSNG modules will have a 4-pin blue ports. Connect Compustar RF antenna to corresponding blue 4 pin port on SmartKey Starter® module
-
Compustar AM remotes and antenna kits are not supported
-
-
-
Follow Compustar RF remote programming procedure
-
Cycle ignition from OFF to IGN 5X. Parking lights will flash 1X
-
If Compustar antenna has a programming button, press the programming button after 5X key cycles
-
Press the lock button on each Compustar remote being programming one at a time
-
Parking lights will flash after each remote is programmed
-
Parking lights will flash 2X when programming is exited
-
Test RF remotes
-
