Introduction
If you have a custom programmer from Mid City Engineering, you may be given multiple programming options to choose from. The programming options are determined by the position of the turn signal/high beam stalk during the programming sequence.
- The default setting of the programmer will always use the stalk neutral position (stalk not up, down, forward, or backward).
- There may also be a revert/remove programming option (removing feature), which will be the stalk up position (right turn signal).
To select a programming option, put the stalk in the corresponding position before starting the programming sequence.
- For custom programming option specifics, consult with Mid City Engineering.
The possible options and stalk positions are as follows:
- Option 1 (default): Stalk neutral
- Option 2: Stalk down/left turn signal
- Option 3 (revert/remove/OEM): Stalk up/right turn signal
- Option 4: Stalk forward (towards hood)
- Option 5: Stalk back (towards rear)
- Option 6: Stalk forward (towards hood) and down
- Option 7: Stalk forward (towards hood) and up
- Option 8: Stalk back (towards rear) and down
- Option 9: Stalk back (towards rear) and up
Note: the OBD programmers are for use in 1 vehicle. Once the programmer is used, it can only be used in the same vehicle again.
Attention: The OBD programmer should be removed after use. Do not start engine or drive vehicle with OBD programmer installed.
Video Overview
-
-
Set turn signal stalk position to choose programing option. For default programming, leave stalk in neutral position. See above introduction above for programming option selection.
-
Press push to start button 2X to turn on ignition
-
Do not start engine
-
Ignition is the 2nd position, all warning lights will be on instrument cluster
-
Press push to start button 1X to turn ignition off
-
This step is to wake up the vehicle
-
-
-
Plug OBD programmer into OBD port
-
LED should turn on (inside case, look through hole at the end of the case)
-
-
-
Press push to start button 2X to turn ignition on
-
Check LED inside programmer
-
When LED turns off, programming is complete
-
Sometimes the programming occurs very quickly (LED turns off immediately after ignition is turned on)
-
If LED does not turn off within 5 minutes, repeat programming steps- but try to complete steps 2 and 3 within 10 seconds.
-
Do not start engine
-
Ignition is the 2nd position, all warning lights will be on instrument cluster
-
-
-
Make sure to remove programmer after process is complete. Do not drive with the programmer plugged in.
-
Attention: The OBD programmer should be removed after use. Do not start engine or drive vehicle with OBD programmer installed.
For support, contact Mid City Engineering:
www.midcityengineering.com/support
312-421-1114
Attention: The OBD programmer should be removed after use. Do not start engine or drive vehicle with OBD programmer installed.
For support, contact Mid City Engineering:
www.midcityengineering.com/support
312-421-1114
