-
-
Unclip plastic cover around mirror mount and lower slightly
-
Unclip center piece of plastic and set both pieces aside
-
This step is also required for installation of the 907ANT factory camera adapter- so if also installing that harness, it is recommended to make that you leave this area disassembled until you run 907ANT harness into headliner
-
-
-
Locate 6 pin camera cable mounted on left side of bracket
-
Un-plug the 6 pin black camera plug
-
-
-
Plug black 6 pin factory camera cable into 6 pin socket on 907CAM harness
-
-
-
Using hand to pull headliner down along windshield, run cable along headliner to 'A' pillar
-
This step through step 8 are also required for installation of the 907ANT factory antenna adapter- so if also installing that harness, it is recommended that the harnessing is run at the same time
-
-
-
Remove trim along 'A' pillar
-
Run and secure cable down 'A' pillar
-
-
-
Remove small plastic panel at end of dash
-
Pull off door seal
-
-
-
Remove 3 x T20 screws along top of bolster pocket
-
Remove 2 x T20 screws along right side of knee bolster
-
Remove 3 x T20 screws along bottom of knee bolster
-
Pull knee bolster panel from dash and set aside
-
-
-
Route cable through dash and behind where radio will be mounted
-
-
-
Plug male RCA from harness into camera input on radio
-
Connect blue wire to reverse trigger on radio
-
It may be necessary to add a relay to the reverse wire. If the camera image is not staying on consistently, is of diminished quality, or cuts out. Add a relay per these instructions.
-
