SKSNGFT Options Settings and Programming

See programming matrix below for feature and option list.

To enter programming:

• Turn key to ACC (1st position)
• Pull turn signal back (towards you) for 10 seconds. Parking lights will flash 1X

To select feature:

• Pull turn signal stalk back (towards you).
• Parking lights will flash once.
• Either select an option (see programming matrix below) or to move to next feature, pull the stalk back again. Parking lights will flash twice, indicating feature 2.
• Continue pulling stalk back until at desired feature. There are 10 features. See programming matrix for feature and option details.

To select option:

• Push turn signal stalk forward (away from you).
• Parking lights will flash once. This is option 1.
• To get to option 2, push stalk forward again and parking lights will flash twice, indicating option 2.
• Continue until at desired option.
• Once at desired feature and option, exit programming.

• Note: if SmartKey Starter® is power cycled (unplugged and plugged back in, vehicle loses power, etc), the settings will return to the default factory settings. Any settings changes made in the field will need to be changed again.

NOTE: IDLE MODE, START/STOP INPUTS and HIGH IDLE on/off do not apply to the part #s SKSNG164, SKSNG211 and SKSNG220

Video below shows an example of option programming. The example shown is feature 4, option 2 (remote engine halt on)