Introduction
Use this guide for the EIS jumper modification for the following SKUs:
-SKSNG166D4T
-SKSNG204D4T
-SKSNG447D4T
This modification is required for the above SKUs. Professional installation is and substantial board-level soldering experience is required. If needed, Mid City Engineering or a distributor will perform the modification. Please contact Mid City Engineering at 312-421-1114 for more information.
-
-
Solder other end of wire to contact where solder was added near optical sensor in step 3
-
-
-
Route bare end of cable through hole drilled in previous step. The bare wires will be connected to board
-
-
-
Carefully put board and cylinder back in housing and re-assemble case and screws
-