-
-
Remove battery from OEM key
-
-
-
Insert key in bracket as shown in picture
-
Make sure that the key is inserted far enough forward through the bracket
-
-
-
Close key box lid and use four (4) included screws to secure lid
-
Note for testing: remote starter will not work if light is getting in box (lid open).
-
-
-
This step assumes that the EIS modification has already been completed. Click here for EIS modification instructions
-
Connect RJ cable from EIS modification into mating plug on key box.
-
-
-
Connect two (2) pin white plug from key box into the mating two (2) pin white plug labeled KEY on SmartKey Starter module
-
Almost done!
Finish Line
