V3

Minor Versionm

by Mid City Support

GL Keyless Go Jumper Harness (KG20166) Installation

Written By: Mid City Support (and one other contributor)
  • Comments: 0
  • Favorites: 0

Difficulty

Moderate

Steps

16

Time Required

00:30:00 - 01:00:00

Introduction

Keyless Go Jumper Harness (KG20166) Installation- only required if vehicle is equipped with Keyless Go (push button start)

    • Fold driver’s middle row seat all the way forward.

  3. Remove torx bolt holding seat belt to rear side panel.

    • Remove torx bolt holding seat belt to rear side panel.

  4. Pull back weather strip on the back side of the rear door opening.

    • Pull back weather strip on the back side of the rear door opening.

  5. Remove screw cover. Remove (1) T-30 torx from inside the rear retractible cover mount.

    • Remove screw cover.

    • Remove (1) T-30 torx from inside the rear retractible cover mount.

  6. Pop side panel partially out.

    • Pop side panel partially out.

    • Route the 166 KG adapter to the rear side panel area.

  8. Reach in and unplug connector on KG module (see picture). Plug removed

    • Reach in and unplug connector on KG module (see picture).

    • Plug removed

  9. Remove the shroud from that connector

    • Remove the shroud from that connector

    • Shroud removed

    • Remove the brown and brown/red pins from the black connector making a note of their position

  11. Install the pins from the 166 KG adapter into the spots where the factory wires were removed.

    • Install the pins from the 166 KG adapter into the spots where the factory wires were removed.

    • KG harness properly installed into plug

    • Reinstall the shroud for that plug.

    • Reinstall the plug into the module.

    • Pop the side panel back into place.

    • Reinstall (1) T-30 Torx and cosmetic cover.

    • Reinstall Torx bolt for seat belt.

Finish Line

Author

with 1 other contributor

Mid City Support

Member since: 7/31/18

73 Guides authored